Enthone
10-000 Series Legend Ink is permanent one-component,
epoxy-based, screen-printing ink. When properly
cured, 10-000 Series Ink will have excellent adhesion
to conventional and UV-curable, liquid photo imageable
and dry film solder resist. Additionally, 10-000
series adheres to glass, plastic and metals. 10-000
Series Ink is resistant to acids, alkalies, fluxes
and soldering operations. Primary uses of 10-000
Series Ink include the marking of circuit boards,
dials, metal, nameplates, components, glass, thermoplastics
and laser mark applications. Must be heat-cured.
Available
in quart, open-top, metal containers and gallon
pails (10-105 only).
Enthone
50-000 Series Cat-L-Inks are permanent, two-component,
epoxy-based screen-printing inks. These legend inks
may be used with a selection of catalysts, which
cure at elevated and/or room temperatures. When
properly applied and cured, Cat-L-Ink has excellent
adhesion to conventional and UV-curable solder resists,
glass, plastics and metals. Enthone 50-000 Series
is extremely resistant to acids, alkalies, solvents,
salt-spray and thermal shock. Enthone 50-000 Series
Cat-L-Ink is used in the electronics, aerospace,
automotive, appliance and decorative container industries.
Uses include permanent marking of circuit boards,
dials, nameplates, components, edge-lit panels,
chassis, glass and thermoplastics. Each ink comes
with a choice of catalyst (Catalyst 5 is excluded
and must be purchased separately).
Enthone
50-000 Series Cat-L-Ink is available in quart containers.
Enthone 50-100R, 50-700R and 50-110RX are available
in gallon containers. Catalyst for quarts is packaged
in special half-pint containers. Must be heat-cured.
Enthone
60-000 Series is a permanent, two component, epoxy-based,
thermal cure, screen-printing ink. It is designed
to print legend on printed wiring boards over bare
copper, base laminate or any solder mask coating.
60-Series has a minimum mixed pot life of two weeks
at ambient temperature. Enthone 60-Series cures
to a semi-matte finish and provides superior performance.
It meets or exceeds Bellcore Legend ink requirements,
passes several IPC-SM-840B, Class 3 solder mask
requirements and meets most of the requirements
of commercial item description A-A56032A. 60-Series
has unsurpassed adhesion to all solder masks or
base epoxy laminates and demonstrates adhesion pull-strength
values exceeding most photo imageable solder masks.
Enthone 60-Series will withstand multiple soldering
operations with no degradation in color. It may
be applied to either side of the circuit board before
hot air solder leveling. 60-Series yellow may also
be used for laser marking bar codes that can be
easily read by bar code scanners.
